User manual



DO NOT INSERT ANY BLANK RJ-45 HEADS INTO ANY

PORTS BEFORE CRIMPING – OTHERWISE YOU WILL

RENDER THE PORT USELESS – BENT PINS

Attach RJ-45 Male heads to your existing wiring and follow

the diagram below. For data only use pins 1,2,3 & 6. For

Data and PoE use all pins. PoE uses pins 4,5,7 & 8

Unpacking The Enable-IT 820P Pro IP PoE Camera Extender Kit

Carefully remove the Enable-IT 820P Pro Kit’s packing materials from the box. Verify that

the items listed below are present. Make sure that the equipment supplied matches what

you ordered. If any items are missing or damaged, please contact Enable-IT or your

distributor for assistance.

 (1) Enable-IT 820P Pro IP PoE Camera Extender Unit

(1) Enable-IT 362 PoE Injector kit 60W – 56V

 (2) LAN Ethernet Patch Cords

 (1) Enable-IT 820P Pro Quickstart Guide

Performing The On-Site Installation

After removing the Enable-IT 820P Pro IP PoE Camera Extender Kit from the box all that

remains to install the unit on-site is to mount the unit, add RJ-45 Male heads to your wiring,

connect the wiring, cross connect voice lines if needed and attach end device Ethernet

patch cord cabling.



Mounting the Enable-IT 820P Pro IP PoE Camera Extender Kit

The Enable-IT 820P Pro Extended Ethernet Units are designed for quick wall

mounting. Choose a location to mount each of the Enable-IT 820’s where the

maximum distance does not exceed 800ft (244m) total between devices to be

connected.

When wall-mounting the units it is recommended that you use the appropriate screw

anchors for your mounting surface. If mounting on existing plywood use wood screws;

if mounting onto drywall or sheetrock, use plastic drywall anchors to secure your

installation.



Attaching cabling and devices to the Enable-IT 820P Pro IP PoE Camera Extender.

Apply power to the 362 PoE Injector kit. Cable the power cord to the 362 power brick

adapter and use it’s DIN DC female connector to attach to the DC jack on the back of

the 362 Injector module.

Attach a RJ-45 LAN patch cord from your local LAN source to the Data N1 port on the

injector. Then run another LAN patch cord from the PoE&Data N2 port to the LAN &

PoE IN port on the 820P Pro unit.



Building the backbone between the 820P Pro unit and your remote LAN.

Crimp RJ-45 LAN heads onto your selected 4-pair wiring and insert into the

Interlink port on the 820P Pro unit and the other end to your LAN.