User manual

Page 8 of 12 Ethernet Extension Experts
INSTALLING THE 350 POWER OVER ETHERNET INJECTOR
Unpacking the Enable-IT 350 Power Over Ethernet Injector
Carefully remove the Enable-IT 350 Power Over Ethernet Injector from all packing
materials in the box. Verify that the items listed below are present. Make sure that the
equipment supplied matches what you ordered. If any items are missing or damaged,
please contact your Enable-IT or your distributor for assistance.
 (1) The Enable-IT 350 Power Over Ethernet Injector
 Enable-IT 350 Power Over Ethernet Injector User Manual (this manual)
Performing the On-Site Installation
 Locate the power source for connecting the supplied power cord and attach this
power cord to Enable-IT 350. You can apply power to the unit.
 Insert a standard Ethernet patch cord to the Data/PoE out port - the other end of the
Ethernet Patch cord is for your PoE equipment or Enable-IT 820 PoE and Ethernet
Extender (Data/PoE in port)
 Insert a standard Ethernet patch cord into the Data In port and connect the other end
of the Ethernet Patch cord to your Local LAN device such as a switch.