User manual
                        Page 10 of 12 Ethernet Extension Experts 
ENABLE-IT LIMITED WARRANTY 
Enable-IT warrants the Enable-IT 350 Power Over Ethernet Injector solely pursuant to the 
following terms and conditions. 
1. PRODUCT WARRANTY 
a. Express Warranty Enable-IT warrants to the original purchaser of the Product ("you" or the 
"End  User")  that,  for  the  one  (1)  year  period  commencing  on  the  date  the  Product  was 
purchased  (the  "Warranty  Period"),  the  Product  will  be  substantially  free  from  defects  in 
materials and workmanship under normal use and conditions. This warranty does not apply 
to Products which are resold as used, repaired or reconditioned or consumables (such as 
batteries)  supplied  with  the  Product.  Electrical  damage  is  not  an  item that  is  covered 
under this warranty or extended warranties. Enable-IT does not make any warranty with 
respect to any third party product, software or accessory supplied with or used in connection 
with the Product and such third party products, software and accessories, if any, are provided 
"AS IS." Warranty claims related to such third party products, software and accessories must 
be made to the applicable third party manufacturer. 
b.  Remedies  for  Breach  of  Warranty  In  the event  of  a breach of  the  foregoing  warranty, 
Enable-IT will, in its sole discretion and at its cost and subject to the terms of the following 
paragraph, repair the non-conforming Product,  replace the non-conforming Product with a 
new or reconditioned Product or refund of the purchase price for the Product. Any new or 
reconditioned Product provided pursuant to this paragraph is warranted as provided herein 
for  the  remainder  of  the  original  Warranty  Period.  THE  REMEDY  SET  FORTH  IN  THIS 
PARAGRAPH  SHALL  BE  THE  END  USER’S  SOLE  AND  EXCLUSIVE REMEDY  FOR 
BREACH OF THE FOREGOING WARRANTY. 
c. Conditions for Warranty Qualification If authorized by Enable-IT to return a Product which 
does not conform to the warranty set forth above, the End User must: (1) obtain a return 
materials authorization (RMA) number from Enable-IT by contacting the Customer Service 
Dept. at 888-309-0910 between the hours of 8:00 a.m. and 5:00 p.m. PST and otherwise fully 
comply with Enable-IT’  then-current RMA policy; (2)  return the Product  to Enable-IT in its 
original packaging freight pre-paid; and (3) provide to Enable-IT the original receipt or bill of 
sale establishing the date on which the Product was purchased. 
Products returned to Enable-IT without an RMA number will be returned to the End User. 
Enable-IT  shall  not  be  responsible  for  damage  or  loss  during  shipment  of  the  returned 
Product to Enable-IT. 
d. Voiding of Warranty.  The express warranty set forth above shall not apply to failure of the 
Product  if  the  Product  has  been  subjected  to:  (i)  physical  abuse,  misuse,  improper 
installation, abnormal use, power failure or surge, or use not consistent with the operating 
instructions provided by Enable-IT; (ii) modification (including but not limited to opening the 
Product housing) or repair by any party in any manner other than as approved by Enable-IT 
in writing; (iii) fraud, tampering, unusual physical or electrical stress, unsuitable operating or  
physical conditions, negligence or accidents; (iv) removal or alteration of the Product serial 
number tag; (v) improper packaging of Product returns; or (vi) damage during shipment (other 
than  during  the  original  shipment  of  the  Product  to  the  End  User  from  Enable-IT,  if 
applicable). 










