Instruction Manual

ManualsBrandsEMX INDUSTRIES ManualsPresence SensorEMX INDUSTRIES OWL Microwave Motion and Infrared Presence Sensor

EMX Industries, Inc. 8/10

OWL_Rev1.0_092220

Additional Functions and Information

Details – IR Rows & Columns

Setting Value

Button

IR Rows – Adjusts which IR LED rows are on; turns off rows furthest from sensor first

IR Columns, Left Side – Turn on/off IR columns in pairs

IR Columns, Right Side – Turn on/off IR columns in pairs

= Off

= On

Reading Settings

Start

Desired Function

Enter

Sensor Output

Finish

thru

Green LED on front of sensor will flash 1-9 times,

confirming the function setting value

Maintenance Mode

Start

Options

Enter

Activate output

relays indefinitely

Cancel output

relays activation

Return to factory

settings

Reset sensor

Note:

LEDs on front of sensor will act as below when outputs are turned on using Maintenance Mode

Blue: Solid

Yellow: Off

Red: Flashing

Security Code

Function

Button

Enter 4 Digit Code

Enter Button

Set Security Code

Unlock Sensor

Delete Security Code

Note: When unlocked, settings may be changed for 60 seconds. The timer stops while a setting is

being configured. The timer extends for 60 more seconds after a setting has been entered.

Note: To reset or delete the security code, power cycle the unit. The unit will not require a security code

for 60 seconds after power-up. Use the “Delete Security Code” function above, then set a new security

code.