Instruction Manual

EMX Industries, Inc. 6/10

OWL_Rev1.0_092220

Programming the OWL

1. If a security code has been programmed on the sensor, then it must be entered before settings can

be changed. Unlock the sensor by pressing the button, then entering the four-digit security code,

and press the enter button ( ).

Unlock Sensor

Function

Four-Digit Security Code

Enter

2. To change a setting, point the end of the remote at the sensor, and press the button of the function

to be changed. The green LED on the front of the sensor will turn off, and other LEDs on the front of

the sensor will turn on.

3. Press one of the possible setting value options ( thru ). The green LED on the front of the

sensor will flash the same number of times as the setting selected.

Not all functions use thru as a valid range of setting values. Please see page 7 for

more information.

4. Press the enter button ( ). The green LED on the front of the sensor will flash four times.

Make sure there are no vehicles in the presence detection area when saving a setting.

The sensor’s infrared sensor relearns the environment when a setting is saved. If there is a

vehicle in the presence detection area while it relearns the environment, then the presence

output will lock on when the vehicle moves.

Programming Settings

Function

Setting Value

Sensor Output

Finish

thru

Green LED on front of

sensor will flash 6 times to

confirm

5. Wait for the sensor to save the setting and relearn the environment. Programming is now finished.

TIP: