Instruction Manual

EMX Industries, Inc. 3/10
OWL_Rev1.0_092220
Installation
1. Unscrew the Philips-head hinge screws from the left and right side. Remove the sensor from the
mounting bracket.
2. In the desired location, install the mounting bracket at a height between 11.5 and 21.3 ft (3.5 and 6.5
m). Drill 1/8” (3.5 mm) mounting holes as shown in the diagram and attach with the provided screws.
3. Re-attach the sensor to the mounting bracket using the Philips-head hinge screws from Step 1.
Adjust to the desired angle, and tighten the hinge screws until snug.
32º (Far)
16º
For ceiling
For wall mount
32º (Far)
16º
Far angles will
provide maximum
Near angles will
result in minimum