Phau Ntawv Qhia

EMX Industries, Inc. Tech support: 216-518-9889 2/8
Document No.10310204 Rev 1.1 [e-mail]
 LRS-C1 Controller (included, required to program and recalibrate the LRS-FP or DB)
 LRS-FP-50 Flat pack sensor 50’ lead-in wire
 LRS-FP-100 Flat pack sensor 100’ lead-in wire
 LRS-DB-50 Direct burial sensor 50’ lead-in wire
 LRS-DB-100 Direct burial sensor 100’ lead-in wire
 LRS-L Logic Interface (optional accessory, can be used to increase size of detection zone size
with multiple sensors or to set-up AB direction control logic)
Wiring Connections
*The shield (bare) wire on the sensor cable should be connected
to earth ground to help prevent electromagnetic interference.
Ordering
Information
Terminal Description Sensor
Shielded Cable
VIN1 Power (12-24 VDC/AC) --
VIN2 Power (12-24 VDC/AC) --
NO Relay – NO (normally open contact) --
COM Relay – COM (common contact) --
NC Relay – NC (normally closed contact) --
NPN_THRU Open Collector Output Terminal 6&7
NPN_THRU Open Collector Input WHITE
RED Sensor Communications A RED
GRN Sensor Communications B GREEN
V+ V+ (sensor positive power) BROWN
V- V- (sensor negative power) BLUE
External Earth
Ground Wire
Earth Ground (not connected on
LRS-C1)
SHIELD*
Operator
Connections
LRS
-
FP or
DB
Sensor
Connections
LRS-DB
LRS-FP
6&7
Connected
on board