Phau Ntawv Qhia

EMX Industries, Inc. Tech support: 1216-518-9889 3/16
Document Number 10370104 Rev 1.1 [e-mail]
Please Note!
 The caller’s ID of the users must be ON (not private) in order for the CellOpener-365 unit
to identify the user when calling the system to gain access.
 For solar applications, to reduce the current consumption of the unit, you can remove
the jumper link on the right-hand side in the unit, to turn off the LEDs after the
installation is complete. See diagram above.
Please make sure that the mobile phone you are using to program this unit has its Caller ID ON.
Follow the instructions below to program the unit by SMS as per instructions below:
1. Adding & Deleting Phone Numbers
You can program and add up to 1600 phone numbers to be as normal users by sending SMS.
The example below shows how to add 2 phone numbers and delete one phone number by SMS:
9999AN.12167315263.12168655002.DE.13302345678
9999 Is the password (default password 9999)
AN Add the following normal number(s).
DE Delete the following normal number(s).
. The dot marks the end of a number or command.
*Note: There is no need for the dot “.” at the end of the SMS command.
The maximum phone numbers are 5 phone numbers that can be added or deleted by one SMS command.
The unit should reply by SMS that says:
Confirming: 12167315263.12168655002 added, 13302345678 deleted.
The unit will disregard any phone numbers that were listed and could not be found in the
system memory of the unit.
2. Deleting All of the Phone Numbers
To delete all the phone numbers, send the following SMS:
9999format
The unit will reply:
Programming