Phau Ntawv Qhia

EMX Industries, Inc. Tech support: 1216-518-9889 10/16
Document Number 10370104 Rev 1.1 [e-mail]
YES
The unit will confirm by SMS:
The unit was set to factory default
*Note: Ignoring the warning message and not replying “YES” within two minutes, will cause the unit to disregard the
defaulting command.
15. How to change the Password
The factory default password is 9999 and it can be changed by sending the following SMS
message where “####” correspond to the new password:
9999password####
The unit will confirm by SMS reply:
The new password is # # # #
16. INPUT – 1: Gate’s Status
This input can be used to check the status of the gate and see if the gate is OPEN or CLOSE. This
is done by connecting a magnetic read-switch to this input and to the ground. If this input is
connected to the ground that means the GATE is CLOSED and if it is not connected to ground
(open circuit) it means the gate is OPEN. To check the status of this input, send SMS command as
follows:
*Note: 9999 Is the password (default password 9999)
9999status
The unit will reply by SMS accordingly.
If input-1 is connected to ground:
The gate is closed
If input-1 is open circuit:
The gate is open
17. How to customize the SMS message for INPUT – 1
You can customize the SMS message which the unit sends when input-1 is triggered to suit
different applications.
You can program different messages by sending SMS message as follows:
9999RS._ _ _ (Max 25 characters) _ _ _._ _ _ (Max 25 characters)_ _ _ ...