Specifications

LightPulse Fibre Channel PCI Host Adapter How to Guide Page 6 of 14
file://G:\emuweb\WWWROOT\ts\fibre-channel\docs\howto pdf\nt_alpa.htm 3/28/99
IOERR_RCV_BUFFER_WAITING 0x0B
IOERR_NO_CONNECTION 0x0C
IOERR_TX_DMA_FAILED 0x0D
IOERR_RX_DMA_FAILED 0x0E
IOERR_ILLEGAL_FRAME 0x0F
IOERR_EXTRA_DATA 0x10
IOERR_NO_RESOURCES 0x11
IOERR_RESERVED 0x12
IOERR_ILLEGAL_LENGTH 0x13
IOERR_UNSUPPORTED_FEATURE 0x14
IOERR_ABORT_IN_PROGRESS 0x15
IOERR_ABORT_REQUESTED 0x16
IOERR_RECEIVE_BUFFER_TIMEOUT 0x17
IOERR_LOOP_OPEN_FAILURE 0x18
IOERR_RING_RESET 0x19
IOERR_LINK_DOWN 0x1A
IOERR_CORRUPTED_DATA 0x1B
IOERR_CORRUPTED_RPI 0x1C
Enable simultaneous networking and storage over Windows NT
By Windows NT default, if a Windows NT SCSI driver is installed, it will load first when
the computer boots, and use the host adapter's default or alternate device ID (View jumper
settings). The Windows NT IP driver loads later, and requires a separate device ID. This ID
is set through jumpers on the host adapter board. Jumper blocks JX1 and JX2 must be set to
enable the correct device ID.
This method requires two host adapters installed in the same computer. One adapter must be
an LP6000, LP7000/E or LP8000.
To run both drivers at the same time,