Specifications

Install the Host Bus Adapter Board
Record IEEE and serial numbers.
Each host bus adapter port is shipped with a unique address identifier
called the IEEE address. Since this adapter has two ports, there are two
IEEE addresses. The IEEE address is used when configuring your
system. The serial number is used when communicating with Emulex.
All numbers are clearly marked on the board. We recommend that you
record these numbers before installing the adapter.
1.
Turn off and unplug the computer.2.
Remove the computer case.3.
Remove the blank panel from an empty 32− or 64−bit PCI bus slot.4.
Insert the host adapter board into the empty 32− or 64−bit PCI bus slot.
Press firmly until it is seated.
5.
Secure the host adapter's mounting bracket to the case with the panel
screw.
6.
Replace the computer case and tighten case screws.7.
The host adapter is now installed in the PC. Continue with the attach media
section.
Emulex Drivers, Software and Manuals
4