User`s guide

INSPEED MODEL 370 EMBEDDED STORAGE SWITCH
USER’S GUIDE CHAPTER 2: SWITCH INSTALLATION
EMULEX CORPORATION 8
P
ART NUMBER 00041367-003 REV. B
Installing the Retention Clips (optional)
The switch ships with two, optional retention clips to secure the power cords in each power supply/fan
module’s power receptacle. Screws (4) and washers (4) are provided for the clips.
To install the retention clip:
1. Secure the retention clip to the switch by aligning the retention clip with the two screw holes
located to the left and the right of the module’s power receptacle. The retention clip mounting
loops should be facing downward.
2. Place the washer on the screw prior to inserting the screw through the retention clip’s mounting
loop.
3. Using a screwdriver, tighten the screws to secure the retention clip to the power supply/fan
module.
To insert the power cord with the retention clip in place:
1. Insert the power cord plug into the module’s power receptacle. The plug must initially be inserted
into the receptacle at an angle to avoid the retention clip.
2. Once the power cord plug is firmly inserted in the module’s power receptacle, the retention clip
fastens over the end of the power cord plug to secure it in the power receptacle.
To remove the power cord with the retention clip in place:
Press down on the retention clip while removing the power cord from the module’s power receptacle.
SWITCH LEDS
The switch incorporates four sets of Light-Emitting Diodes (LEDs) to indicate ethernet, switch, port, and
power supply/fan module status:
1. Ethernet LEDs – two separate LEDs indicating the network connection status.
2. System LEDs – four separate LEDs indicating the switch’s status.
3. Port LEDs – two LEDs per port indicating the port’s status.
4. Power Supply/Fan LED – a separate LED for each power supply/fan module indicating the
power supply/fan module’s status.
Figure 2-1: Switch View Depicting Ethernet, Port, and System LEDs
Port LEDs
Ethernet LEDs
System LEDs
Figure 2-2: Switch View Depicting Power Supply/Fan LED
Power Supply/Fan LED
Power Supply/Fan LED