Operating instructions

VOICE DEFINITION MODULE

23 - VIBRATO DEPTH

This function determines the extent to which the LFO (vibrato) signal modulates

the Current Voice pitch.

1. With the module active, Current Voice assigned (see GENERAL

INSTRUCTIONS 2), and the ENTER LED either lit steadily or off, key in 23. The

display says:

Vibrato Depth 00

Slider A determines the extent to which the LFO modulates the Current Voice

pitch, with higher values (up to 15) giving greater vibrato depth. Vibrato rate,

delay, and variation are set in the VCA/LFO module (see VCA/LFO 2).

Note: This control interacts with the Real Time Control module vibrato control

(see REAL TIME 4). Selecting Real Time vibrato disables this function, and vice-

versa.

2. To exit to another function, see GENERAL INSTRUCTIONS 3 (“Exiting a

Function”).

24 - VOICE ATTENUATE/TUNE

This function attenuates selected Voices assigned to a Preset, thus attaining a

proper balance between all Voices; the tuning of each Voice can also be trimmed

± approximately one half-step.

1. With the module active, Current Voice assigned (see GENERAL

INSTRUCTIONS 2), and the ENTER LED either lit steadily or off, key in 24. The

display says:

Atten Pitch

-XXdB YXXCents

...where Y indicates + or -, and XX is a value between 00 and approximately 48.

2. Adjust Slider A to attenuate the Current Voice relative to the other Voices.

3. Adjust Slider B to change the pitch of the Current Voice relative to the other

Voices.

4. To exit to another function, see GENERAL INSTRUCTIONS 3 (“Exiting a

Function”).