Operating instructions

VOICE DEFINITION MODULE

S000004 LXXXXX

AutoLp:Press Yes

...and the ENTER light flashes. S is the Start point of the loop, and L is the loop

Length in samples. Initially, S is set to the beginning of the Voice (approximately

000000) and L equals the length of the sample.

3. Remember -- L sets the Length, not the end point, of the loop. Example:

Consider the loop in Fig. VDEF- 5. When S moves, the loop end point (as

determined by the loop Length) moves in tandem with S.

Fig. VDEF– 5

Hint: If the loop Length is at maximum (as occurs when you first call up a Voice

for looping), you cannot set a new S point since that would force the loop to “run

out of sample” (see Fig. VDEF- 6). Shorten the Length before moving the S

point.

Fig. VDEF– 6

1 2 3 4

Same as Fig VDEF- 5, except

that START has moved far

enough to place the end point

beyond the end of the sample.

1 2 3 4

s S1 moves to S2 the loop

length follows along to create a

new end point