Operating instructions

THE GUIDED TOURS

Note: You can have different Performance disks in both drives, and load a Bank from either disk

(but not both simultaneously) by using the appropriate command (GET BANK DISK 1 or GET

BANK DISK 2). Loading in a new Bank will erase any currently loaded Bank.

Loading instructions for single-drive Emulator II:

1. Remove the old Performance disk from Drive 1, then insert and latch the new

Performance disk into Drive 1.

2. Refer to DISK 1 (“Get Bank Disk 1”), follow the instructions, and then return to this

section.

TUNING THE EMULATOR II TO OTHER INSTRUMENTS

Refer to MASTER CONTROL - TUNE. This function demonstrates how the Emulator II uses the

slide controls to set parameters. In this case, only one of the four sliders is used. However,

when setting such parameters as ADSR values for the filter or VCA, all four sliders are used.

TRANSPOSING THE KEYBOARD

Refer to MASTER CONTROL - TRANSPOSE.

FORMATTING DISKS

Format an equal number of Performance and Library disks (at least two of each) according to

the instructions given in DISK 8, “Formatting a Performance or Library Disk”. These will come in

handy during future guided tours.