Operating instructions

SEQUENCER MODULE

3. Slider B selects one of the following metronome values:

1/4 quarter note

1/4 t quarter note triplet

1/8 eighth note

1/8 t eighth note triplet

1/16 sixteenth note

1/16 t sixteenth note triplet

click A 24 pulses-per-quarter note click track is send from the MET OUT jack.

4. To continue with the setup process, select the next function (SEQUENCER

SETUP 4). To return to the Module Identifier, press ENTER.

SETUP 4 - Function: CUE

This function lets you cue (monitor) any or all of the tracks recorded in the

Sequencer.

1. With the SETUP sub-module active, key in 4. If you have not yet recorded any

tracks, the display says:

Tracks:

Cue On:

As you record tracks, the track number appears on the top line and an asterisk

appears below each recorded track on the bottom line. For example, if you have

recorded on tracks 3, 4, 5, and 8, the display shows:

Tracks: 3 4 5 8

Cue On: * * * *

2. To turn off a track, press the track number on the keypad; the asterisk will

disappear. To turn the track back on again, press the track number on the

keypad; the asterisk will reappear.

3. To continue with the setup process, press ENTER to return to the Module

Identifier, then select the next function (SEQUENCER SETUP 5).

Hint: When using the Sequencer for live performance, cue can be used to turn

“alternate” tracks on and off. For example, you could record two or three different

solos on different tracks, and cue up a different solo for each set so that fans who

see the band a lot won’t hear the same solo night after night.