Operating instructions

SEQUENCER MODULE

DEFINE 4 - SUPERMODE

This function allows the EII to receive MIDI Information over 8 different channels,

and sound them through 8 different presets simultaneously! To use Supermode,

you must first create a Supermode map which routes the MIDI channels to specific

presets.

To create the Supermode map:

1. Define a new sequence and record a short, blank sequence of any length (don’t

play any notes). Each track you record listens to it’s corresponding MIDI channel.

Track 1 listens to MIDI channel 1, track 2 listens to channel 2, track 3 to channel

3, and so on. Repeat the blank recording process on any track whose MIDI

channels you wish to use.

2. Activate the EDIT module and select 5 (REASSIGN PRESET). Assign each track

to the desired preset. You now have a Supermode map that you can copy to

other sequencer locations. By simply changing sequences, you can call up a new

map!

To use the Supermode map:

1. Check that the EII’s MlDl IN connects to the external sequencers MIDI OUT.

2. Make sure that the current preset is in OMNI mode (PRESET DEFINITION 30)

and turn it’s sequencer START/STOP setting to off.

3. Activate the DEFINE module and select 4. The display says:

Supermode: no

Press Y/N

Press ON to enable Supermode. The EII will now respond to multiple MIDI

channels and route them to the preset specified in the Supermode map.

Supermode is only active while the EII sequencer module is active.