Operating instructions

DISK MODULE

2 - GET BANK DISK 2

A Performance disk stores one Bank of Presets (plus the Voices that make up the

Presets). Loading the Bank into the machine lets you play with the Presets and

Voices that make up the Bank.

When the machine is first turned on, simply inserting and latching a Performance

disk into Drive 2 will initiate loading a Bank. At all other times use this function to

load a new Bank into memory from a Performance disk inserted in Drive 2.

1. Remove any existing disk from Drive 2, then insert and latch the Performance

disk containing the Bank to be loaded in Drive 2.

2. With the disk module active, key in 2 to GET BANK DISK 2. The drive clicks, its

LED lights, and the display tells you that...

This Will Take

A While

After loading (about 20 seconds), the display then shows the Current Preset.

P03*

* or 1st Preset to appear upon loading

Note: If you try to get a Bank from a Library disk, which of. course doesn’t store

data in a Bank, the display will read:

Insert Perf Disk

And Press Enter

Insert a Performance disk, press ENTER, and continue.

3. To choose a different Preset, enter its number with the keypad (see GENERAL

INSTRUCTIONS 1, “Selecting the Current Preset”).

4. To choose which Current Preset will be active when you load a Bank, select the

desired Preset just before saving the Bank to disk (see DISK 7, “Save Bank”).

The Emulator II will default to that Preset whenever you load the Bank.