Operating instructions

PRESET DEFINITION MODULE

Range: C1 to C1

Play a Key

This is the default setting and indicates that arpeggiation will only play in the range C1 to

C1(one note). Press the key corresponding to the lowest note in the range you want

arpeggiated (after which the cursor will move to the second note in the display), then

play the key corresponding to the highest note in the range you want arpeggiated. The

display will confirm your choice. If you make a mistake, the cursor will jump back

underneath the lowest note, and you can start the assignment process over again.

Note: The Emulator II will not let you choose a lower note higher than the currently

selected upper note.

5. After selecting the

range, move Slider A upwards until the display says:

Note Value: 1/16

Use Slider D

Use Slider D to select between the following arpeggiation note values: 1/4, 1/4 triplet,

1/8, 1/8 triplet, 1/16 (default setting), 1/16 triplet, 1/32, and 1/32 triplet.

6. After selecting the note value, move Slider A upwards until the display says:

Tempo: 120

Use Slider D

Use Slider D to select a tempo in the range of 40 to 240 beats per minute. Note that

tempo moves in 1 BPM increments from 40 to 120 BPM, 2 BPM increments from 120 to

162 BPM, and 3 BPM increments from 162 to 240 BPM. If you have selected an

External Clock (see SEQUENCER EXT CLK), the arpeggiator will follow this clock rather

than the internal clock.

7. You have now completed arpeggiator set-up. To exit to another function, see GENERAL

INSTRUCTIONS 3.