Operating instructions

PRESET DEFINITION MODULE

11 - GET VOICE

This fetches the specified Voice from a Library disk and loads it into the Bank.

Application: Before creating Presets, you must load the Voices that make up the Preset(s) into

the Bank.

1. With the module active, key in 11. The display says:

Get Voice __

(01 – 99)/Slider A

..and the ENTER light will be flashing. Either use the keypad to specify the Voice File to

be loaded, or move Slider A to catalog (see GENERAL INSTRUCTIONS 7) the Voice

Files available for loading. When the display shows the desired Voice, press ENTER.

2. The display now says:

FXX (Voice Name)

Into Voice VV

...where XX is the two-digit Voice file number (see GENERAL INSTRUCTIONS 4 on

Library disk Voice numbering protocol), and VV is the lowest-numbered Voice number

available in the Bank. The display will always default to the lowest available Bank Voice

number. To assign this number to the Voice, press ENTER. To assign a different Voice

number, use the keypad and then press ENTER.

3. The disk drive will whirr for a bit and load the Voice file into the Bank. After loading, the

Module Identifier appears.