Operating instructions

VOICE DEFINITION MODULE

27 - BACKWARDS MODE

This function reads the Voice out of memory in the reverse order from which it

was stored. .derots saw ti hcihw morf redro esrever eht ni yromem fo tuo ecioV

eht sdaer noitcnuf sihT

Applications: Backwards tape effects simulation. Reverse attack and decay

characteristics of Voices.

1. With the module active, assign the Current Voice (see GENERAL

INSTRUCTIONS 2).

2. After assigning the Current Voice (the ENTER LED will be off), key in 27. The

display says:

Backwards: no

Press Y/N

...and the ENTER light will flash. This confirms that the default setting is NO. To

initiate Backwards mode, press YES then ENTER To cancel a previously initiated

backwards mode, press NO then ENTER Either answer will return you to the

Module Identifier.

Note: When backwards mode encounters a loop, it will play backwards to the

loop Start point, then jump to the loop end point and play through to the Start

again. With VOICE DEFINITION 13 (forward/reverse loop), the sample will play

backwards to the Start point, then forwards to the loop end, then backwards to

the Start point, etc. (see Fig. VDEF-18).