User's Manual

Page 8 of 12
Document # E.0015.16.07 443713.DOC
4 Enrolling Procedure
4.1 General
Note: Assignment of units to protect specific zones should be completed before enrolling
procedure may be implemented. See Control Panel Installer Manual, Section 3.2, Installer
Function Programming, for instructions.
Note
: The Installer functions can only be implemented by the system installer. If an
ordinary User or Master ID or an incorrect code is entered for any Installer function, an
INCORRECT ID prompt will be displayed and an "Incorrect ID" voice prompt will sound.
After 1 second, an ENTER ID prompt will be displayed and an "Enter ID" voice prompt will
sound. (After three incorrect ID entries, the system will respond with an INCORRECT ID
prompt and an "Incorrect ID" voice message, followed by an ACCESS DENIED prompt
and an "Access Denied" voice message, and access to the system from the Control Panel
will be denied for a preprogrammed interval of time.)
Note
: The Enroll procedure should be performed continuously. If a pause of more than 20
minutes (default time) occurs, the installation will be terminated and the opening screen
will again be displayed, without saving the installation data.
Note
: At any point in any Installer function, pressing OK at top of Control Panel will move
one level downward in the menu structure; pressing C key at top of Control Panel will
move one level upward in the menu structure.
All Control Panel programming functions are implemented by means of the four keys (OK,
C, DOWN, UP) at the top of the Control Panel and the numeric keypad.
4.2 Siren / Strobe Unit Enrollment
To access the Main Menu, press OK at top of Control Panel when system is disarmed and
opening screen is displayed. Screen will show:
MAIN MENU
1: USER
Use the DOWN key to select:
MAIN MENU
3: INSTALLER