User's Manual

Page 11 of 12
Document # E.0015.16.07 443713.DOC
5 Place Test
From the Enroll Zones menu as shown in Section 4.2 above, press DOWN key at top of
Control Panel. Screen will show:
INSTALLER MENU
11: PLACE TEST
Note: This operation refers to the unit for which Section 4.2 was just performed.
Press OK at top of Control Panel. Screen will show:
PLEASE ACTIVATE
THE ZONE
Go to the location where the siren / strobe unit is to be installed, temporarily mount the unit
and connect it to mains. The unit will transmit its serial number, type and mode to the
Control Panel.
If the Control Panel receives this information from the unit within a predefined time, screen
will show:
S/N: XXXXXX
SIREN [STATUS]
If the signal level for this unit is OK, the buzzer will sound and screen will then change to:
SIGNAL LEVEL
OK
If the signal level for this unit is not OK, the buzzer will not sound and screen will then
change to:
SIGNAL LEVEL
TOO LOW
Note: For first time installation for this system, Section 5 must be repeated for each siren /
strobe unit in the system.