IntegrAlarm USER AND INSTALLER MANUAL 5-FUNCTION KEYFOB IntegrAlarm MODEL IA-FOB-1 February 09, 2004 Document # E.0015.16.
Table of Contents 1 IntegrAlarm Overview..................................................................................... 3 2 5-Function Keyfob (Remote Control Unit)................................................... 5 2.1 Description ....................................................................................................... 5 2.2 Technical Specifications ................................................................................. 5 2.3 Installation ............................
1 IntegrAlarm Overview The IntegrAlarm wireless security system includes a Control Panel and a number of wireless peripheral units. The system operates on the ISM wireless band of 902-928 MHz, in frequency hopping mode, transmitting short (about 10 ms) packets of data, with each packet transmitted on a different frequency. Time and frequency synchronization is maintained by a synchronization signal transmitted by the system Control Panel to the various peripherals every 3 minutes.
FCC Compliance Statement The FCC Wants You to Know This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
2 5-Function Keyfob (Remote Control Unit) 2.1 Description The multifunction keyfob consists of an RF transceiver, a micro-controller, a keypad and a battery. The multifunction keyfob is composed of the following principal parts: • RF/controller PCBB assembly with LED. • Housing with keypad. • Battery, 2 X N1/3 cells An exploded view of the multifunction keyfob is shown in Figure 1 below. 2.2 Technical Specifications Operating frequency band – ISM 902-928 MHz.
2.3 Installation Installation of each multifunction keyfob is a two-step procedure. The multifunction keyfob should first be registered via the IntegrAlarm Control Panel. It should then be tested to confirm that it operates properly. 2.3.1 Registration From Installer Menu on Control Panel, select ENROLL. Screen will show: ENTER ZONE # Use numeric keypad at right of Control Panel to enter the desired zone number. The description of the zone number (e.g. MASTER BEDROOM) will appear at bottom of screen.
Home arming mode. Press HOME again and observe Control Panel display to ensure that the IntegrAlarm System is disarmed. • Standing near the Control Panel, press AWAY. Ensure that the LED first flashes red (indicating transmission to the Control Panel) and then green (indicating receipt of ACK response from the Control Panel). Observe Control Panel display to ensure that the IntegrAlarm System enters Away arming mode.
Document # E.0015.16.
