User's Guide

Page 19 of 46
Document # E.0015.16.02 406985
automatically switch to Smart Away arming. (Note: Smart Arming cannot
be implemented from a keyfob or telephone.)
3.3.2 Instant Home / Away Arming
Instant arming means that there will be no Entry Delay – that is, an alarm
will be issued immediately upon entrance to the building, if the system is
not disarmed from outside via keyfob or telephone.
To implement Instant arming (Home or Away), first press the HOME or
AWAY key at left of Control Panel; enter User ID if required (see Section
3.3.1 above) and proceed as for normal Home / Away arming. When the
series of beeps signaling the Exit Delay begins, press the HOME or
AWAY key again. When the Exit Delay expires, the word ARMING will be
replaced by INSTANT HOME or INSTANT AWAY. When INSTANT HOME
or INSTANT AWAY appears, a beep will sound and an appropriate voice
message will be given. The system is now armed in Instant mode.
(Note
: For Instant arming from keyfob, see Section 3.3.6 below; from
telephone, see Section 3.3.7 below.)
3.3.3 Disarming
To disarm the system, ensure that system is armed (ARM is displayed on
Control Panel) and press the OFF key at left of Control Panel. (Note
: For
disarming from keyfob, see Section 3.3.6 below; from telephone, see
Section 3.3.7 below.)
An ENTER ID prompt will be displayed and an "Enter ID" voice prompt
will sound. Enter your User ID.
If the ID entered at any stage of the process is incorrect
, the system will
respond by displaying an INCORRECT ID prompt and an "Incorrect ID"
voice prompt will sound. After 1 second, an ENTER ID prompt will be
displayed and an "Enter ID" voice prompt will sound. Enter your User ID.
(Note
: After three incorrect ID entries, the system will respond with an
INCORRECT ID prompt and an "Incorrect ID" voice message, followed
by an ACCESS DENIED prompt and an "Access Denied" voice message,
and access to the system from the control panel will be denied for a
preprogrammed interval of time.)