User's Guide

Page 18 of 46
Document # E.0015.16.02 406985
the Exit Delay. A series of beeps will sound until the countdown time
reaches 0. (Note
: If Away arming is implemented, user should leave the
building during the Exit Delay; otherwise, once the system is armed, any
movement within the building will issue an alarm.) When the Exit Delay
expires, the word ARMING will be replaced by ARM HOME or ARM
AWAY. When ARM HOME or ARM AWAY appears, a beep will sound and
an appropriate voice message will be given. The system is now armed.
If Quick Arming is enabled
, an ENTER ID prompt will not be displayed. As
soon as the AWAY key is pressed, if the system is ready
, the word
ARMING will be displayed on Control Panel along with a countdown time
indicating the Exit Delay, and the arming will proceed as in the previous
paragraph.
If the system is not ready
, and if Force Arming is not enabled (default
state; see Section 3.6.4 below), a NOT RDY: message will be displayed,
listing the number of the sensor which is not ready and the nature of the
problem (OPEN, TAMPER, LOW BAT, ZONE LOST).
If the sensor which is not ready can be bypassed
, a BYPASS? message
will be displayed.
To bypass the faulty zone, press OK at top of Control Panel; the word
ARMING will be momentarily displayed on Control Panel, and will then be
replaced by ARM. When ARM appears, a beep will sound. The system is
now armed.
To abort the arming (in order to remedy the problem): when the
BYPASS? message is displayed, press ESC at top of Control Panel. The
word DISARM will appear on Control Panel, indicating that the arming
has been aborted.
If the sensor which is not ready cannot be bypassed
, an OK? message
will be displayed. Press OK at top of Control Panel. The word DISARM
will appear on Control Panel, indicating that the arming has been aborted.
Smart Arming
: This feature enables the user to arm the system by
entering the User ID without having selected HOME or AWAY. When the
User ID is entered with no function selected, Home arming will take place
as described above. If one of the zones used to exit the building opens
and closes while the system is Smart Home armed, the system will