Installation Guide

Page 57 of 67 pages
Document # E.0015.16.03 406984
Press OK at top of Control Panel. Screen will show:
01: PWR FAIL E1
Restore E2 ↵
To confirm the hexadecimal codes which will indicate in the report
that a power failure event has occurred and that the system has
subsequently been restored to normal operation, press DOWN at
top of Control Panel. To change the default, key in the desired codes
on numeric keypad and press OK and then DOWN at top of Control
Panel to proceed to next sub-function. Screen will show:
02: L. BATT. EV E3
Restore E4 ↵
To confirm the hexadecimal codes which will indicate in the report
that a low battery event has occurred in the Control Panel and that
the system has subsequently been restored to normal operation,
press DOWN at top of Control Panel. To change the default, key in
the desired codes on numeric keypad and press OK and then
DOWN at top of Control Panel to proceed to next sub-function.
Screen will show:
Repeat the process described in the previous paragraph for each of
the following sub-functions:
03: TLN ALERT
04: RTC ALERT
05: LOG FULL
On conclusion of all sub-functions (when sub-function 01 is again
displayed), press ESC to return to Maintenance menu. Now press
DOWN at top of Control Panel to proceed to the next sub-function,
Misc. Codes
.
Screen will show:
REPORTING CODES
9. Misc. Codes
Press OK at top of Control Panel. Screen will show: