Installation Guide

Page 43 of 67 pages
Document # E.0015.16.03 406984
To change the start time, press OK at top of Control Panel. The first
"0" will blink. Using the numeric keypad like a cellular telephone
keypad, change the "0" to the desired digit. The next "0" will then
blink. Change the "0" to the desired digit. Now do the same for the
third "0" and the fourth "0", followed by "0" for AM and "1" for PM.
Now press DOWN key at top of Control Panel to proceed to next
sub-function.
Screen will show:
09: STOP TIME
03:50 P
If 00:00 AM is the correct stop time, press DOWN key at top of
Control Panel to proceed to next sub-function.
To change the stop time
, press OK at top of Control Panel. The first
"0" will blink. Using the numeric keypad like a cellular telephone
keypad, change the "0" to the desired digit. The next "0" will then
blink. Change the "0" to the desired digit. Now do the same for the
third "0" and the fourth "0", followed by "0" for AM and "1" for PM.
On conclusion of all sub-functions (when sub-function 01 is again
displayed), press ESC. Screen will again show:
X-10 No: 1
APPLIANCE 1
To repeat the above process for X-10 No. 2, press DOWN key at top
of Control Panel. Screen will show:
X-10 No: 2
APPLIANCE 2
Repeat all of the above steps for X-10 No. 2 through 8.
On conclusion of all sub-functions (when sub-function 01 is again
displayed), press ESC to return to X-10 Options menu. Now press
DOWN key at top of Control Panel to proceed to the
Communications Options menu.