Installation Guide

Page 40 of 67 pages
Document # E.0015.16.03 406984
blink. Change the "0" to the desired digit. Now do the same for the
third "0" and the fourth "0", followed by "0" for AM and "1" for PM.
On conclusion of all sub-functions (when sub-function 01 is again
displayed), press ESC. Screen will again show:
PGM No: 1
GATE
To repeat the above process for PGM No. 2, press DOWN key at top
of Control Panel. Screen will show:
PGM No: 2
GARAGE DOOR
Repeat all of the above steps.
On conclusion of all sub-functions (when sub-function 01 is again
displayed), press ESC to return to Output Options menu. Now press
DOWN key at top of Control Panel to proceed to the X-10 Options
menu.
3.2.6 X-10 Options
From the Output Options menu as shown in Section 3.2.5 above,
press DOWN key at top of Control Panel. Screen will show:
INSTALLER MENU
6: X-10 OPTIONS
This defines the output options for the X-10 devices used for the
system.
Before viewing the options for the first X-10 device, it is necessary to
set the house code (the code for the network on which the X-10
appliances are located). From the X-10 Options menu, press OK at
top of Control Panel. Screen will show:
01: HOUSE CODE
A ↵
To confirm A as the house code and view the options for the first X-
10 device, press OK at top of Control Panel. To change the house
code and view the options for the first X-10 device, key in a one-digit