Installation Guide

Page 20 of 67 pages
Document # E.0015.16.03 406984
07: INT. SIREN
*Pulse A ‡
To select internal siren type for this zone (Note: a list of internal siren
types appears in the Appendix to this manual), press DOWN or UP
keys at top of Control Panel until desired internal siren type is
displayed, and then press ESC key followed by DOWN key at top of
Control Panel to proceed to next sub-function.
Screen will show:
08: EXT. SIREN
Continuous ↵
If Continuous is the correct setting for this zone, press DOWN key at
top of Control Panel to proceed to next sub-function.
To change the external siren type, press OK at top of Control Panel.
The ↵ character will be replaced by ‡. Screen will show:
08: EXT. SIREN
*Continuous ‡
To select external siren type for this zone (Note: a list of external
siren types appears in the Appendix to this manual), press DOWN or
UP keys at top of Control Panel until desired external siren type is
displayed, and then press DOWN key at top of Control Panel to
proceed to next sub-function.
Screen will show:
09: REPORT DELAY
10 ↵
If 10 seconds is the correct report delay setting for this zone, press
DOWN key at top of Control Panel to proceed to next sub-function.
To change the report delay time
, press OK at top of Control Panel.
The "1" in 10 will blink. Using the numeric keypad like a cellular
telephone keypad, change the "1" to the desired digit. The "0" will
then blink. Change the "0" to the desired digit. Now press DOWN
key at top of Control Panel to proceed to next sub-function.
Screen will show: