Installation Guide

Page 18 of 67 pages
Document # E.0015.16.03 406984
To enable the chime function and proceed to next zone attribute,
press DOWN key at top of Control Panel. To change the default from
Enable to Disable, press OK at top of Control Panel (if Disable is
displayed, press OK at top of panel to change to Enable) and then
press DOWN key at top of Control Panel to proceed to next sub-
function. Screen will show:
02: BYPASS ENABLE
Disable ↵
To disable the zone bypass function and proceed to next zone
attribute, press DOWN key at top of Control Panel. To change the
default from Disable to Enable, press OK at top of Control Panel (if
Enable is displayed, press OK at top of panel to change to Disable)
and then press DOWN key at top of Control Panel to proceed to
next sub-function. Screen will show:
03: FORCE ARM
Disable ↵
To disable the force arm function and proceed to next zone attribute,
press DOWN key at top of Control Panel. To change the default from
Disable to Enable, press OK at top of Control Panel (if Enable is
displayed, press OK at top of panel to change to Disable) and then
press DOWN key at top of Control Panel to proceed to next sub-
function. Screen will show:
04: CROSS ZONE
Disable ↵
To disable the cross zone function and proceed to next zone
attribute, press DOWN key at top of Control Panel. To change the
default from Disable to Enable, press OK at top of Control Panel (if
Enable is displayed, press OK at top of panel to change to Disable)
and then press DOWN key at top of Control Panel to proceed to
next sub-function. Screen will show:
05: STROBE TYPE
Strobe None ↵
If no strobe exists for this zone, press DOWN key at top of Control
Panel to proceed to next sub-function.