Installation Guide

1. Unpack the lock and loosen the set screws at the bottom of each Lever. Remove Levers from Inner Housing

and unthread the Rosettes from Inner Housings.

2. Install inner housings onto surface of door orienting the notch on the housing to the bottom. The two wood

screws should be located at the top and bottom.

3. Thread the Rosettes into the Inner Housings and slip Levers into Inner Housings. Tighten the set screws at

the bottom of each Lever.

Installation Instructions for

Dummy Key in Lever Lockset

Inner Housing

Orient Notch to Bottom

Wood Screws

Set Screw

IN4-KEYNLVRDMY

REV. 11/16/04

PAGE 1
Installation Instructions for Dummy Key in Lever Lockset 1. Unpack the lock and loosen the set screws at the bottom of each Lever. Remove Levers from Inner Housing and unthread the Rosettes from Inner Housings. 2. Install inner housings onto surface of door orienting the notch on the housing to the bottom. The two wood screws should be located at the top and bottom. 3. Thread the Rosettes into the Inner Housings and slip Levers into Inner Housings. Tighten the set screws at the bottom of each Lever.