User manual

EMS SYSTEM 5000
USER MANUAL, ISSUE 2.4 – 19/11/09
8
6.2 ON Position Functionality: (Access Level 2)
The Control Panel requires the control keyswitch
turned to the “ON” Position, enabling Access Level 2: -
The key may not be removed when in this position.
Scroll Buttons Operational when multiple events are
displayed to enable each event to be viewed.
Reset/Led
Test
This button has two functions. It is firstly
used to reset a Fire/Fault Event, after the
“Silence Alarm” button has been pressed and
the Fire/Fault condition has been cleared. It
is secondly used to test all of the Systems
Status Lamps. This is achieved by pressing
the button when the Systems Status is
normal, i.e. no events displayed.
Silence Alarms This button Silences the System’s Sounders
and internal buzzers. The panel will give an
intermittent beep every 10 – 15 seconds until
the condition is reset and will display Silence
Alarms when pressed.
Sound Alarms This key is used for activating the System’s
Sounders. The display will show Alarms
Sounded when pressed.
View Tests 2
nd
Feature
of key
Displays any device/zone currently in test.
This will automatically timeout and return to
the front screen if left in this mode.
View
Disablements
2
nd
Feature
of key
Displays any device/zone currently disabled.
This will automatically timeout and return to
the front screen if left in this mode.
View Faults 2
nd
Feature
of key
Displays any device currently in fault
condition. This will automatically timeout and
return to the front screen if left in this mode.
View Fires 2
nd
Feature
of key
Returns to view fire events if any of the other
view options used. This will automatically
timeout and return to the front screen if left
in this mode.
Status Lamps,
(see fig 2)
N/A
Indicates the systems current status.
System Menus
N/A
Options and further Fire system Options
Menus are now accessible by pressing the “0”
Key. Details are shown in Section 7.
ISOLATED
OFF
ON
ON position