User manual

EMS SYSTEM 5000

USER MANUAL, ISSUE 2.4 – 19/11/09

(A) Options:

FUNCTION DESCRIPTION

Passwords Contains 7 sub menus. This allows the option to change,

edit and delete PIN numbers if used.

Time and Date Gives the option to set and view the Time and Date.

Logging Enables you to view the entire log of events, (up to 1000

events), or to view the log at a certain date.

Fire System Options Allows access to (B) Fire System.

(B) Fire System:

FUNCTION DESCRIPTION

Dev. Disable/Test This option enables an individual device that forms part

of the fire system to be Disabled, Activated or put into

Test. The status lamps will illuminate/extinguish as

appropriate.

Net. Disable/Test This option enables the user to control individual devices

that are logged onto other control panel’s on the

Networked Fire System. Such as a smoke detector or call

point to be changed from their normal active status, to

be disabled or put into test.

Det Zone Dis/Test This option allows the Detection Zone to be viewed and

altered. The zone can be either Active, Test or Disable. If

any zones on the system are disabled or in test mode the

relevant LED Indicators will light to indicate this.

Alarm Zone Disable This option allows the disablement of groups of sounders

within the system. The Alarm Zone can be either Enabled

or Disabled. If Disabled the relevant LED indicator will

illuminate.

ARE Disable This option allows connection to the Fire Brigade via the

Brigade Relay to be disabled. Therefore any subsequent

fire activation’s will not operate this relay. The panel

operation, although unaffected, will display the text

“ARE/BRIGADE DISABLED” to ensure the system is not

left in this mode.

System Mode This option allows enablement of up to eight different

system modes of operation. These are pre-programmed

and can be changed if required by the

Installer/Maintenance Contractor.

Engineers Config This option when entered prompts for a PIN number to be

entered to Allow access to Level 3. This menu is for

Installer/Maintenance Contractor use only.

Printer Options This option allows the Printer, when fitted, to be both

“Enabled” and “Disabled”. When “Enabled” and the

option is set to ALL, every Event is printed out. This

option can also be set to FIRE, which will then only print

Fire Events.