User manual

EMS Dr. Thomas Wünsche

CG-ARM7/D/ECAN/CAN Gateway

Example:

# PIDs for CAN channel 1

# CAN 1: 11-bit IN-Id: 0x5

pidin1 = x5

# CAN 1: 29-bit OUT-Id: 0xA00

xpidout1 = xA00

# PIDs for CAN channel 2

# CAN 2: 29-bit IN-Id:0x6E

# xpidin2 = x6E

# CAN 2: 29-bit OUT-Id: 0x1FFE

# xpidout2 = x1FFE

During the configuration process via CAN it is needed that the

device can clearly be identified inthe network. Thisprocess is based

on the serial number of the device.

If there is the need to have the configuration process independent of

the the serial number, a device id can be assigned. Then the

identification of the device depends on the device id and not on the

serial number.

Care must be taken to use a particular device id just once in a

network, if more than one gateway is used.

The device id can have values beween 1 and 99999999.

Example:

deviceid = 50

deviceid device identifier