User's Manual

LEDs are flashing, there is an alarm condition and you should refer to the
Operator’s Manual to troubleshoot the problem.
Note that any unused ports on the Hub will indicate an alarm condition until the
user commands the Hub to ignore those ports. Please refer to the Operator’s
Manual for further details.
Each Remote has one alarm LED. When power is first applied to the Remote, its
LED will be amber for a period of 10 seconds. After the initial period, the LED
will indicate either an alarmed condition or normal operation. A solid green LED
indication on the Remote is normal and means that everything is functioning
properly. If any of the Remote LEDs are not green, there is an alarm condition.
Refer to the Operator’s Manual to resolve the problem.
3.10 User/Guest Login
When the Hub Controller first powers up, there is a start-up message indicating
the firmware release and copyright legends:
Hub Controller Program V0.99 [Build 04Oct02]
Copyright (c) 2002, EMS-Technologies, Inc.
If the user presses the ENTER key, the login prompt is displayed:
Hub Controller Program V0.99 [Build 04Oct02]
Copyright (c) 2002, EMS-Technologies, Inc.
Username:
There are two basic types of login available to the customer: Guest, and User.
The guest login is for simple monitoring of the unit, but the ability to change
settings is quite limited. The user login is for the customer use and allows basic
system changes to be made to the module. Note that the login username and
password are CASE-SENSITIVE.
Hub Controller Program V0.99 [Build 04Oct02]
Copyright (c) 2002, EMS-Technologies, Inc.
Username: user
Password: ****