User's Manual

EMS Wireless Operator’s Manual
EkoLite II
28
catastrophic events as the fiber to the Remote being cut. For a Hub that
does not use all eight channels, the unused channels will report an alarm by
default. These are false alarms and it will be necessary for the user to
disable these unused channels to clear the alarms.
The command to disable the unused channels is:
2>set fiber <n> = disabled
Where n corresponds to the desired channel. In the event that the wrong
channel is inadvertently disabled or a remote is added at a later time the
disable channel should be enabled using the following command.
2>set fiber <n> = on
Where n corresponds to the desired channel.
2.9.4 Offsets
Under normal conditions, the factory default power settings are configured to
provide +12 dBm output power (1900 MHz models), or +8 dBm (800 MHz
models) at each remote. The factory settings will provide optimum
performance in most environments; however the user has the option to
change the power settings in each remote according to individual
requirements.
Set an “offset” to the default value for the desired remote. For example, to
set remote 1 to +18 dBm type:
2>set remote 1 = -2
The range for the offsets is –10 dB to +0 dB and can only be set in 1 dB
increments. In this way, each remote can be tuned to the user’s specific
requirements after the system is deployed.
To verify the offsets for each remote the following command may be used:
2> get remote n
where n is the number of the specific remote offset requested.