User's Manual

EMS Wireless

EMS Wireless EkoMini Manual

Setting up your EkoMini: For the EkoMini to Report Alarms, the unit must be

first connected to a telephone line. To activate the unit to remotely report alarms,

the unit must be contacted by modem via a computer, the setup procedure

completed and the unit issued the Activate Report Alarms Command: (set rp actv

= yes). If any of these steps are skipped the unit will not function properly.

STEP 1. Contacting the EkoMini.

This can be achieved by using ANY Hyper Terminal Program.

A. Set to the following parameters.

BAUD : 2400

Word : 8

Stop : 1

Parity : None

Flow : None

Terminal Emulation: Auto Detect

Note: The EkoMini has a factory Default Auto Answer Set for 2 Rings. After

The Unit answers, the prompt "Welcome to the Remote System

" will

appear.

B. Press the ENTER key. The Prompt : "Password?" Will appear.

C. Enter a valid password and press enter.

Note: If this is the first time the unit is contacted it should be done with a

supervisors default password of: 11111 so that the Passwords can be

changed.

D. Changing Passwords:

PW 1 = Password 1 change. 5 Characters or Numbers (supervisors PW)

PW 2 = Password 2 change. 5 Characters or Numbers

PW 3 = Password 3 change. 5 Characters or Numbers

E. Set Site Location Number

UN = (Unit Name change, 10 numeric characters, Default Serial

Number)