User's Manual

EMS Wireless
EMS Wireless EkoMini Manual
12
A factory default password is preprogrammed into the unit as 11111. The user may
change this in the program mode of operation. There is also a factory access
password.
Up to three numbers and alarm codes or paging pin numbers can be sent. The unit
will send an alarm to the first number when an alarm occurs. (The alarm is not sent
during the red flashing alert period. It is delayed 5 minutes to be certain the alarm will
not clear itself). Each additional number and alarm, which has a programmed
sequence, will be sent after the programmed delay. The delay, which is set, is a time
measurement from initially sending the first telephone call and alarm. The three
telephone numbers are entered with the following information:
1. Telephone Number 20 digits, maximum
Include required access codes such as 9 if required by a
PBX. A comma is used to insert a delay.
Pin 10 digits
Alarm Code 20 numeric digits
2. Telephone Number 20 digits, maximum
Include required access codes such as 9 if required by a
PBX. A comma is used to insert a delay.
Pin 10 digits
Alarm Code 20 numeric digits
Delay 3 numeric digits, 0 to 999 minutes
3. Telephone Number 20 digits, maximum
Include required access codes such as 9 if required by a
PBX. A comma is used to insert a delay.
Pin 10 digits
Alarm Code 20 numeric digits
Delay 3 numeric digits, 0 to 999 minutes
Telephone number 2 delay is the time between dialing out number 2 after number 1
has been dialed. Accordingly telephone number 3 delay is the time between dialing
out number 3 after number 2 has been dialed.
Should an alarm condition clear, the EkoMini will send an Alarm Clear alert to the
same number or numbers that were alerted previously. As an example the alarm
condition could occur if the base station was turned off for maintenance.
The unit will record time, date and cause of the last 25 reportable (alarms present after
5 minute alert delay) alarms. The user may download these via the modem connection