User's Manual

CI Wireless Inc. 1211 Ira E Woods Ave 53
Tel: [phone] Grapevine, TX 76051
Using the 1-meter fiber optic jumpers provided connect the Hub optical unit to
the WDM
Hub-FO Input to WDM-1310
- FO Output to -1550
Fiber Optic link cable will connect to WDM connection marked FC/APC
.
DANGER: INVISIBLE LASER RADIATION AVOID DIRECT
EXPOSURE TO BEAM.
-Apply Power and follow set up instructions.
IMPORTANT! Before performing maintenance on any internal module, make
sure power is OFF.
9.4 Mounting the Microcell Unit
-Mount Microcell unit
-Connect coaxial cable to antenna
-Connect fiber Optic cables.
-Wave Division Multiplexer option:
WDM unit is mounted internally in the unit if it was ordered as an option.
Fiber Optic cables were shipped separately to avoid damage, connect as follows:
Fiber Module-Fiber Input to WDM-1550
- Fiber Output to WDM-1310
Fiber Optic link cable will connect to WDM connection marked FC/APC
-Connect Primary AC power.
Connect Back Up Battery option or DC power. (There is no switch on the DC
power connection to the unit. Power may be removed or connected with the
connector on the bottom of the unit or by removing the DC fuse.)
DANGER: INVISIBLE LASER RADIATION AVOID DIRECT
EXPOSURE TO BEAM.