Users Manual Part 3
Table Of Contents
- 3. System Fails Post-Installation Checks
- 4. Incorrect Navigation Data
- 5. System Will Not Connect to the Network
- 6. Connectivity of Each Ethernet Port
- SECTION 7 – MAINTENANCE AND REPAIR
- 1. Maintenance Requirements
- 2. Continued Airworthiness, FAR 25.1529
- 3. Airworthiness Limitations
- 4. General Instructions for Inspection
- 5. Electrical and Mechanical Inspection and Check
- 6. Instructions for Continued Airworthiness
- 7. Visual Inspection and Check
- 8. Scheduled Maintenance and Inspections
- 9. Unscheduled Maintenance
- 10. Repair Requirements
- APPENDIX A – ENVIRONMENTAL CHARACTERISTICS
- APPENDIX B – INFORMATION SHEETS
- 1. Aircraft Information Sheet
- 2. JetWave™ MCS-8562 Terminal AES Subsystem Components
- A. JetWave™ MCS-8562 Terminal AES OAE - FMA Installation Information Sheet
- B. JetWave™ MCS-8562 Terminal AES KANDU Installation Information Sheet
- C. JetWave™ MCS-8562 Terminal AES BUC-HPA Installation Information Sheet
- D. JetWave™ MCS-8562 Terminal AES Modman Installation Information Sheet
- E. JetWave™ MCS-8562 Terminal AES APM Installation Information Sheet
- APPENDIX C – CHECKLISTS
- APPENDIX D – CUSTOMER PORTAL
- 1. Customer Portal
- 2. APM Request Form
- A. Requester Name
- B. Requester Email
- C. Honeywell Representative Name
- D. Hon Representative Email
- E. PO Number
- F. DP/VAR/Customer Name
- G. DP/VAR/Customer Name Contact Name
- H. DP/VAR/Customer Name Contact Email
- I. Channel Partner/Integrator/STC
- J. Estimated APM Due Date
- K. Aircraft Make / Aircraft Model
- L. Aircraft Model Variant
- M. Additional Notes/Comments
- 3. APM Parameter File
- 4. Request Assistance
CategoryConditionSection
BHumidity6
NOTE: At least six spot checks are required.
B and EOperational shocks and crash safety7
CAT S, CURVE C
CAT R, CURVE C1
Vibration8
NOTE: The sinusoidal sweep rate not to exceed 0.5 octaves/minute
EExplosive atmosphere9
Y and WWaterproofness10
FFluid susceptibility - De-ice fluids only11
D and SSand and dust12
FFungus resistance13
SSalt fog14
BMagnetic effect15
X - not requiredPower input16
X - not requiredVoltage spike17
X - not requiredAudio frequency conducted susceptibility18
ZCInduced signal susceptibility19
YQRadio frequency susceptibility20
NOTE: Q (custom) only - SW/CW (un-modulated) signal Operational:
200V/m for 100 MHz to 12 GHz
0.1 V/m 12 GHz to 16.6 GHz
No damage:
200V/m for 12 GHz to 16.6 GHz
0.1 V/m for 16.6 GHz to 18 GHz
Cat H Modified.Emissions of RF energy21
NOTE:
Extension of conducted emissions limits to 200 MHz at 3 dBµA.
Extension of radiated emissions to start at 45 dBµV/m at 150 kHz continuing linearly to 40dBuV/
m at 2MHz, then continuing linearly to 36.3dBuV/m at 30MHz then continuing linearly to 44.5
dBµV/m at 100 MHz. The standard category H curve to follow beginning at 100 MHz.
A3K3L3Lightning induced transient susceptibility22
NOTE: Pin Injection waveform 5A level 125V/125A and 400V/4A. Single stroke WF 4, level 3
(extended to 300V/1000A), Multi-stroke WF4 level 3 (extended to 120V/400A 1st stroke, 75V/
150A subsequent strokes).
X - not requiredLightning direct effects23
BIcing24
Page A-6
23-15-84
EFFECTIVITY
ALL
11 Nov 2020
© Honeywell International Inc. Do not copy without express permission of Honeywell.
SYSTEM DESCRIPTION, INSTALLATION, AND MAINTENANCE MANUAL
JetWave™ MCS-8562 Terminal