Users Manual Part 3
Table Of Contents
- 3. System Fails Post-Installation Checks
- 4. Incorrect Navigation Data
- 5. System Will Not Connect to the Network
- 6. Connectivity of Each Ethernet Port
- SECTION 7 – MAINTENANCE AND REPAIR
- 1. Maintenance Requirements
- 2. Continued Airworthiness, FAR 25.1529
- 3. Airworthiness Limitations
- 4. General Instructions for Inspection
- 5. Electrical and Mechanical Inspection and Check
- 6. Instructions for Continued Airworthiness
- 7. Visual Inspection and Check
- 8. Scheduled Maintenance and Inspections
- 9. Unscheduled Maintenance
- 10. Repair Requirements
- APPENDIX A – ENVIRONMENTAL CHARACTERISTICS
- APPENDIX B – INFORMATION SHEETS
- 1. Aircraft Information Sheet
- 2. JetWave™ MCS-8562 Terminal AES Subsystem Components
- A. JetWave™ MCS-8562 Terminal AES OAE - FMA Installation Information Sheet
- B. JetWave™ MCS-8562 Terminal AES KANDU Installation Information Sheet
- C. JetWave™ MCS-8562 Terminal AES BUC-HPA Installation Information Sheet
- D. JetWave™ MCS-8562 Terminal AES Modman Installation Information Sheet
- E. JetWave™ MCS-8562 Terminal AES APM Installation Information Sheet
- APPENDIX C – CHECKLISTS
- APPENDIX D – CUSTOMER PORTAL
- 1. Customer Portal
- 2. APM Request Form
- A. Requester Name
- B. Requester Email
- C. Honeywell Representative Name
- D. Hon Representative Email
- E. PO Number
- F. DP/VAR/Customer Name
- G. DP/VAR/Customer Name Contact Name
- H. DP/VAR/Customer Name Contact Email
- I. Channel Partner/Integrator/STC
- J. Estimated APM Due Date
- K. Aircraft Make / Aircraft Model
- L. Aircraft Model Variant
- M. Additional Notes/Comments
- 3. APM Parameter File
- 4. Request Assistance
Table 6-1. L1, L2 and L3 Codes (Cont)
Repair actionLog type
L3L2L1
DescriptionCode
Descrip-
tion
Code
Descrip-
tion
Code
Status
Message
Data Loader
Disconnected
9
Software
Configuration
FDFMA4
Status
Message
Operating
Image List
A
Software
Configuration
FDFMA4
Status
Message
Secondary
Image
Corruption
Warning
B
Software
Configuration
FDFMA4
Status
Message
OTA Staged
Software
DataLoad
C
Software
Configuration
FDFMA4
Replace the FMA
Critical Faults
Missing OAE
Factory
Alignment Data
81
Software
Configuration
FDFMA4
check connection
between FMA and
KANDU
Critical Faults
Heartbeat
failure
0
Software
Runtime
FEFMA4
looking for
accompanied critical
fault and address
those
Critical Faults
General Module
Failure
1
Software
Runtime
FEFMA4
Status
Message
LRU mtd
partition
unlocked
5
Software
Runtime
FEFMA4
Run EUI tool to
reformat flash
Critical FaultsFile System Full20
Software
Runtime
FEFMA4
check wiring between
LRUs. If problem
persist, contact
support for removal
Critical FaultsPost Timeout50
Software
Runtime
FEFMA4
reboot the system, if
problem persist,
replace the FMA
Critical Faults
Network
Service
4F
Software
Runtime
FEFMA4
Replace the WBFMA
Critical Faults
FPGA
VERSION
INCOMPATIBLE
WITH THE WB
FMA VARIANT
900
Software
Runtime
FEFMA4
Status
Message
PCU CCA1
Tempera-
ture
FFFMA4
Page 6-33
23-15-84
EFFECTIVITY
ALL
11 Nov 2020
© Honeywell International Inc. Do not copy without express permission of Honeywell.
SYSTEM DESCRIPTION, INSTALLATION, AND MAINTENANCE MANUAL
JetWave™ MCS-8562 Terminal