Users Manual Part 2

(2) Locate Data Load Enable switch. Make sure that the Data Load Mode Enable switch is in
DISABLED position.
(3) Locate the SATCOM power switch. Turn the SATCOM system on.
(4) Wait for 2 minutes for the JetWave™ MCS-8562 Terminal to boot.
(5) Open an Internet browser using Monitoring laptop. Type URL “172.29.55.1” or
“http://172.29.55.1”.
NOTE: The proper IP address may depend upon the installation’s APM configuration
file settings.
(6) Use the applicable login account with well defined password in the login page for accessing
the interface level required. The login for the maintenance interface and user interface is
as follows:
Access maintenance interface with Username: “Maintenance” and Password:
“Earthbound”.
-
- Access the user interface with Username: “User” and no password.
Figure 6-1. AES GUI Login Page
F. Connecting Monitoring equipment to the JetWave™ MCS-8562 Terminal for a Dataload Operation:
(1) Locate JetWave™ maintenance port. Connect monitoring laptop via Ethernet cable to the
JetWave™ MCS-8562 Terminal.
(2) Locate Data Load Enable switch. Make sure that the Data Load Mode Enable switch is in
ENABLED position.
(3) Locate the SATCOM power switch. Turn the SATCOM system on.
(4) Wait for 2 minutes for the JetWave™ MCS-8562 Terminal to boot.
(5) Open an Internet browser using Monitoring laptop. Type URL “172.29.55.1” or
“http://172.29.55.1”.
NOTE: The proper IP address may depend upon the installation’s APM configuration
file settings
Page 6-2
23-15-84
EFFECTIVITY
ALL
11 Nov 2020
© Honeywell International Inc. Do not copy without express permission of Honeywell.
SYSTEM DESCRIPTION, INSTALLATION, AND MAINTENANCE MANUAL
JetWave™ MCS-8562 Terminal