Users Manual Part 2

(3) Mission Configuration file Activation:
(a) Once the Mission Configuration files are loaded, they are displayed on the Mission
Configuration page. Select the ACTIVATE button against the file to activate that
file. Once active, the ACTIVATE button legend changes to Active. Only one file
can be set as active at any given time.
(4) Switching of Modem Mode:
(a) The switch to the external modem mode is allowed only when the AES is in normal
operation and IF Switch is installed and active Mission Configuration file is present.
The switch is performed by using any of the following input methods and is based
on its priority configured in APM:
- Modman discrete input External Modem Enable
- AES GUI Switch Modem Mode page (Refer to Figure 5-18)
- SNMP MIB honAkModemSelection (Refer to TN-90400224).
(b) If the APM parameter Discrete Enable is configured as enabled, then switching
occurs considering only the discrete input. If the APM parameter Discrete Enable
is configured as disabled and the APM parameter GUI Enable configured as
enabled, then switching occurs considering either the GUI or SNMP input. If both
the APM parameters Discrete Enable and GUI Enable’ are configured as disabled,
then switching occurs considering only the SNMP input.
Page 5-44
23-15-84
EFFECTIVITY
ALL
11 Nov 2020
© Honeywell International Inc. Do not copy without express permission of Honeywell.
SYSTEM DESCRIPTION, INSTALLATION, AND MAINTENANCE MANUAL
JetWave™ MCS-8562 Terminal