Users Manual Part 2
Table Of Contents
- SECTION 4 – SOFTWARE CONFIGURATION
- SECTION 5 – SYSTEM COMMISSIONING
- SECTION 6 – TROUBLESHOOTING
E. Manual Steering of the Antenna
To do a commanded test to manually steer the antenna, navigate to "Manual Antenna Steering"
under the commanded test menu. Monitor the antenna movement in accordance with the
commanded test fed through the GUI tool. Refer to Figure 5-9.
NOTE: New Radomes should be checked for any possible interference with normal Antenna
movement prior to activation. This can be accomplished many ways using manually
steering the Antenna with the Radome/Tail Cap lightly attached to structure. Placing
masking tape along critical paths inside the Radome and looking for breaks and removal
in the tape after test is one method of detecting interference. If there is interference, it
must be addressed prior to Radome installation.
Page 5-24
23-15-84
EFFECTIVITY
ALL
11 Nov 2020
© Honeywell International Inc. Do not copy without express permission of Honeywell.
SYSTEM DESCRIPTION, INSTALLATION, AND MAINTENANCE MANUAL
JetWave™ MCS-8562 Terminal