Users Manual Part 2

B. System Health and Configuration
The JetWave™ MCS-8562 Terminal LRUs are shipped with the operational software preloaded.
Refer to SECTION 4 SOFTWARE CONFIGURATION to verify that all of the LRUs are at the same
software level, or if a software upgrade is required for any of the LRUs.
Make sure that the JetWave™ MCS-8562 Terminal LRUs are wired and all the receptacles are
connected in accordance with applicable interconnection diagram.
Power up the JetWave™ MCS-8562 Terminal LRUs, close applicable aircraft circuit breakers to
supply power. After 5 minutes, check the Modman front panel for the Modman status.
There are two LEDs on the front panel of Modman. One is for the power and the second one is
for status. Use Table 5-1 to identify the current operating mode of Modman with the power LED
indicating powered up status.
Table 5-1. Modman LED Status Indications
ModeStatus LED
No electrical power/electrical power is supplied but prior
to boot.
Off
Modman initializationFlash green at a minimum of 10 seconds
Modman in normal operationOn - green
Modman in Fault ModeOn - red
On completion of AES system installation activities, the installer can view and make sure that the
JetWave™ MCS-8562 Terminal LRUs status, AES configuration settings, discrete input and output
status, and antenna alignment status through the GUI as described in this section.
Once the Modman is powered up, the JetWave™ MCS-8562 Terminal GUI page can be accessed.
The JetWave™ MCS-8562 Terminal GUI service is supported on AV1 10/100 Base T Ethernet
interface. The Modman static IP address assigned is 172.29.55.1 and the port number for the AES
GUI service is 80. The laptop's Ethernet port will need to be configured with a static IP address of
172.29.55.x, where x is 10 or above.
Connect a laptop to the AV1 port of Modman through aircraft Ethernet interface. It is recommended
to use a laptop computer with the following minimum requirements:
Intel i5 CPU-
- 8 GB of RAM
- At least 500 MB of available hard drive space
Page 5-3
23-15-84
EFFECTIVITY
ALL
11 Nov 2020
© Honeywell International Inc. Do not copy without express permission of Honeywell.
SYSTEM DESCRIPTION, INSTALLATION, AND MAINTENANCE MANUAL
JetWave™ MCS-8562 Terminal