Users Manual Part 2

Table Of Contents

6 Assert the data load enable discrete noting that installations may connect

this Modman input to a switch or to another aircraft subsystem.

7 Use the ARINC 615A data loader to discover the JETWAVE system data

loadable LRUs including Modman, KANDU, BUC-HPA, APM, and FMA.

a APM Data Load

(1) Choose the desired APM file for the install. Refer to

Appendix D for obtaining the file.

(2) Load the desired .luh file on the data loader.

(3) Start the data load of the APM.

(4) The progress reported by the LRU stays at 0 percent

during file transfer. The progress will jump to 10 percent

when the files are fully transferred and are being

unzipped. Expect a total load time of up to 5 minutes for

the APM.

(5) If the load fails, reboot the system by de-asserting the

data load discrete. Wait 10 minutes, then re-assert the

data loading discrete and restart the load for that unit.

You may have to restart the data loader tool to

re-establish communication with the LRU. If multiple data

load failures are experienced, refer to JETWAVE-23-0006

for repair instructions.

(6) Data Load Completion

Once data loading all required LRU software releases

are completed, switch the data load enable discrete to

the disabled state, this will cause a system reboot.

(b) Loading with Satcom Loader

1 Data Loading the APM LRU

a Select “JETWAVE APM” from the drop down menu of the main

screen. Navigate to the “Utilities” tab as seen in Figure 4-6, and

click “Discover Direct”. A window will pop up verifying that the

LRU is communicating with the JetWave Loader tool.

Acknowledge the window pop-up by clicking OK

Page 4-11

23-15-84

EFFECTIVITY

ALL

11 Nov 2020

SYSTEM DESCRIPTION, INSTALLATION, AND MAINTENANCE MANUAL

JetWave™ MCS-8562 Terminal