Users Manual Part 2

Table Of Contents

E. Load APM configuration files

(1) The APM configuration files are install specific and should be loaded before the rest of the

installation is performed. For instruction on obtaining the files, refer to Appendix D.

NOTE: The following procedure supports any ARINC 615A data loader that supports

the ARINC 665-2 file format. If you do not have the ARINC 615 data loader

tool, the Honeywell Satcom Loader has been made available. Refer to the

Service Bulletin for instructions on setting up JetWave Loader or 615A

dataloader for JetWave™ MCS8562 system

(a) Generic Load Procedure

NOTE: The IP address used to connect to the JETWAVE system may differ

based on customer APM configuration. The following procedure is

applicable to the default setting.

1 Power on the JETWAVE system.

2 Connect the data load PC to the JETWAVE system with an Ethernet

connection enabled for data loading.

NOTE: Typically this connection will be the JETWAVE system AV1

port but may be different for each aircraft type.

3 On the data load PC, open a web browser and in the location bar enter

IP address 172.29.55.1, and then press “Enter”. This will open the AES

GUI as shown in Figure 4-4.

Page 4-7

23-15-84

EFFECTIVITY

ALL

11 Nov 2020

SYSTEM DESCRIPTION, INSTALLATION, AND MAINTENANCE MANUAL

JetWave™ MCS-8562 Terminal