Users Manual Part 2
Table Of Contents
- SECTION 4 – SOFTWARE CONFIGURATION
- SECTION 5 – SYSTEM COMMISSIONING
- SECTION 6 – TROUBLESHOOTING
Figure 4-3. Internet Protocol Version 4 (TCP/IPv4) Properties
Afterwards, open a Windows Command Prompt terminal and type “ipconfig”, which will print the
list of network configurations on the PC. Find the name of the Ethernet adapter (ex. CONTROL
(P4) ) in which the Modman Ethernet is connected to, and verify that the IPv4 address and Subnet
Mask match what was configured in the steps above.
D. Overview
This section contains the instructions for data loading of JetWave™ MCS-8562 Terminal software
to any of the JetWave™ MCS-8562 Terminal LRUs through the Ethernet interface maintenance
port of Modman. Data loading of JetWave™ MCS-8562 Terminal can be performed while:
JetWave™ MCS-8562 Terminal is in normal operation-
Page 4-4
23-15-84
EFFECTIVITY
ALL
11 Nov 2020
© Honeywell International Inc. Do not copy without express permission of Honeywell.
SYSTEM DESCRIPTION, INSTALLATION, AND MAINTENANCE MANUAL
JetWave™ MCS-8562 Terminal