Users Manual Part 2

Table Of Contents

C. Windows PC IP Configuration for Data Load

On the data loader PC NIC (network interface controller) card, assign this static IP address and

subnet address to the Ethernet port that will be connected to the Modman:

IP address: 172.29.55.10-

- Subnet address: 255.255.255.0.

NOTE: The above IP and subnet addresses are based on what is set in the Aircraft Services

Configuration File in the APM. The IP can differ between customer specifications, but

generally this IP layout is used. If in doubt, verify what data load IP is configured in the

APM. The static IP assigned to the Ethernet port on the PC needs to be in the same

subnet as the data load IP (i.e 172.29.55.X).

On a Windows PC, this can be done by navigating to Control Panel -> Network and Sharing Center,

then selecting the Ethernet connection as shown in Figure 4-1. In Figure 4-1, the Ethernet connection

from the Modman has been arbitrarily named “CONTROL” and it is in the P4 slot of the NIC card.

Figure 4-1. Network Settings Page

Once the Ethernet connection has been selected, it will open a Properties page. Select the “Internet

Protocol Version 4 (TCP/IPv4)” item in the presented list, and click "Properties", as seen in Figure

4-2.

Page 4-2

23-15-84

EFFECTIVITY

ALL

11 Nov 2020

SYSTEM DESCRIPTION, INSTALLATION, AND MAINTENANCE MANUAL

JetWave™ MCS-8562 Terminal